A slipped panel is a glass unit that has slid down its glazing bars, leaving a gap at the top and often pushing past the eaves at the bottom. Send photos from Long Eaton (NG10) and we'll tell you which it is — with the price agreed in writing before any work.
Is it time for slipped glass panel repairs?
- Glass edge overhanging the eaves more than its neighbours
- A leak at the top of one pane only
- A pane that looks out of line with the others
Common causes we find
Missing setting blocks
Blocks under the bottom edge carry the weight of the unit; if they're missing or crushed, the unit creeps down.
Loose cappings
If the capping no longer clamps the glass firmly, the unit can creep with thermal movement.
About Long Eaton and the NG10 area
Snow and ice sitting at the eaves can block a lantern's drainage and push water back under the glass as it melts. If your lantern leaks after a thaw rather than after rain, tell us — it points to the eaves and kerb.
From Derby to Long Eaton is roughly 9 miles — all part of the Derbyshire area we cover.
If you're just outside Long Eaton, we also cover Ilkeston (5 miles), Nottingham (6 miles), West Bridgford (6 miles).
How much should it cost?
Guide price for slipped glass panel repairs: £195–£445 ex VAT (£234–£534 inc VAT), per panel. Towers or scaffold, where needed, are priced into the quote. Your fixed price is confirmed in writing before any work starts.
Do you need permission in England?
Straightforward repairs — resealing, gaskets, cappings, eaves and like-for-like parts — don't normally need building regulations approval in England. Replacing the whole lantern or enlarging the opening is different and falls under the Building Regulations 2010; we confirm in writing which route applies before any replacement. Listed buildings need listed building consent from the local council for alterations, and conservation areas can have extra controls; like-for-like repairs are treated differently from changes, so check with the council's conservation officer first.
How does it work?
- Send photosWhatsApp or upload a few photos and tell us when it leaks.
- Guide priceWe reply with a guide price and whether a visit is needed.
- Fixed price in writingYou approve the price and the date before anything starts.
- Repair and testWe fix what's failed, water-test where it matters, and send photos.
Slipped glass panel repairs in Long Eaton: questions
Do you need to visit to price slipped glass panel repairs?
Not always. Clear photos are often enough for a guide price. Where the cause isn't obvious, a visit to inspect and water-test is charged from £145 ex VAT, confirmed before we come.
Can you repair a lantern someone else installed in Long Eaton?
Yes. We repair lanterns whoever fitted them. If yours is still under the installer's warranty, contact them first so you don't affect it.
What does resetting a slipped panel cost?
Usually £195–£445 ex VAT per panel, confirmed in writing before work starts. If the unit is damaged it may need replacing.
Can a slipped panel be pushed back up?
Not safely without removing the capping. The fix is to support the unit properly so it can't slip again.
Other lantern repairs in Long Eaton
- Roof lantern resealing in Long Eaton
- Ridge and hip repairs in Long Eaton
- Upstand and kerb repairs in Long Eaton
- Misted glass unit replacement in Long Eaton
- Timber roof lantern repairs in Long Eaton
- uPVC roof lantern repairs in Long Eaton
Slipped glass panel repairs near Long Eaton
More about slipped glass panel repairs · All roof lantern repairs in Long Eaton